Viewing engineering order schedule details

In this page, you can view the EO schedule details for the component to which the EO is applicable`. You can view the component to which the EO is applicable and view the date on which the EO has been last performed. The flying hours and cycles or engine hours or cycles in which the EO has been performed and the remaining number of hours or cycles available for EO can also be viewed.

Select the hyperlinked engineering order number in the multiline of the “Select EO” page.

The “View EO Arisings Information” page appears.

The system displays the following in the “EO Details” group box:

EO #	The selected engineering order for which the schedule details are to be viewed.
Revision No	The revision number of the engineering order.
Subject	The textual description of the engineering order.
Status	The status of the engineering order, which could be “Fresh”
Applicability	Indicates whether the EO is applicable to “Engine” or “Component”.
EO Category	The category to which engineering order belongs.
ATA #	The ATA chapter on which the EO must be executed.
MCR #	The MCR number associated with the EO.

The system displays the following in the “Component Arisings” multiline:

Part #	The part number of the component.
Serial #	The serial number of the component.
Component #	The component ID to which the engineering order is applicable.
Last Performed Date	The date on which the engineering order was last executed on the component.
Last Performed Value - Hours	The flying hours or engine hours at which the engineering order was last executed on the component.
Last Performed Value – Cycles	The flying cycles or engine cycles in which the engineering order was last executed on the component.
Available Life – Days	The remaining life, in days, of the component.
Available Life – Hours	The remaining life, in hours, of the component.
Available Life – Cycles	The remaining life, in cycles, of the component.
Part Description	The textual description of the part.

Note: The system displays the parameter values in the multiline based on the option “Decimal Format” or “HHMM Format” selected for the parameter in “Time Display Option” drop-down list box in the “Aircraft” business component while parameter creation. For e.g. If the Time Display Option is selected as “HHMM Format” and the value stored is 2.50 in the data base, the system displays 2.30 in the multiline.