Selecting engineering document for revising its details

This page allow you to displays the engineering documents that are already created for the change request selected in the “Select Change Request”. Tell me more.

Select the “Revise Existing engineering document” link at the bottom of the “Select Change Request” page.

The “Select engineering document” page appears.

The system displays the following:

Change Request	The change request number for which the existing engineering document has to be revised.
Revision	The revision number of the change request.
Change Doc Type	The type of the change document, which could be “MCR”.

Note: The system displays all the “Released” and the “Closed” engineering documents that are already created for the change request.

The system displays the following in the “Eng. Doc. Details” multiline:

Eng. Doc #	The engineering document number created for the change request.
Revision #	The engineering document revision number that helps in tracing the changes made to the engineering document.
Applicability	The engineering document applicability, whether the engineering document is applicable for “Aircraft”, “Component” or “Engine”.
Status	The status of the engineering document, which could be “Released” or “Closed”.
User Status	The user defined status of the engineering document.
ATA #	The ATA chapter on which the engineering document must be executed.
Eng. Doc Category	The category of the engineering document.
Subject	The description of the engineering document.

Check to box in the “Select” column of the multiline, to mark the engineering document for which you wish to revise the details.

To proceed, carry out the following

Click the hyper linked engineering document number in the multiline to revise the details.

Selecting engineering document for revising its details – An overview

Each revision of the change request need not result in an engineering document. Depending on the nature of the revision, the MCM decides whether a new revision number needs to be generated. The decision by the MCM on these revisions will result in the creation of a new engineering document or the revision of an existing engineering document. If the MCR revision leads to a revision in the work scope, then the existing engineering document(s) can be revised. In this page, you can select the engineering document to be revised.

The system displays the engineering documents that are already created for the change request selected in the “Select Change Request” page. The details such as engineering document number, revision number, applicability, status, user status, ATA chapter on which the engineering change has to be performed, category to which the engineering document belongs, and description are displayed. The system retrieves engineering documents that are in the following status:

Released: When the engineering document is finally released for execution the status of the engineering document is changed to “Released”.
Closed: When the engineering document is closed after execution.

You can select an engineering document and revise the details in the “Revise Existing Engineering Document” page.